Two short add a leafs with new center bolts can be the ticket when only 2-2.5" of lift is desired.
The add a leaf is 2 3/8 inches wide in the center and flares to 2 1/2 inches wide on the end.
Add-a-leafs are designed to be used with stock leaf springs, not aftermarket springs with additional leafs or higher arch.
These add-a-leafs are commonly used in conjunction with rear lift blocks in a taller system to beef up the rear springs.
Remember that rear spring fatigue is common in older vehicles, especially SUV's and rigs used for hauling and towing.
These short add-a-leafs install toward the bottom of the spring pack.
Normally with short leafs, ride firmness is increased slightly more than it would be with long add-a-leafs.
Short leafs are slightly easier to install.
All kits include two single leafs and new tie-bolts.
Degree shims may be required to realign rear driveshaft angle on some vehicles if driveline vibration occurs.
Heavy, riveted-on factory spring clips can generally be reused.
NOTES:
Jeff's Bronco Graveyard strongly recommends using new U-bolts, nuts and washers with this installation.
These leafs are up to 1" thick in the middle. | 
