New
1988-96 Ford Bronco
1986-96 F150, F250, F350
With 351W V8 Engine
Ships Directly from Manufacturer
Normally takes 2-4 weeks
|
|
|
|
FLOW KOOLER V8 WATER PUMP
FLOWKOOLER, maker of high-output automotive waterpumps, has increased the number of impeller blades from eight to 16 blades on this Bronco water pump, further increasing the low RPM performance of their product.
The new patent-pending MIRAKOOL 16 (M-16) FLOWKOOLER impeller more than doubles the water flow rate at idle, yet drops back to stock output at 3,500 RPM, avoiding too much water flow at higher RPM.
By doubling the GPM output, FLOWKOOLER water pumps solve engine overheating at idle. Independent testing by a major engineering university and the world's largest automotive manufacturer has proven FLOWKOOLER pumps out-perform all other makes at low speeds.
GENERAL SPECIFICATIONS:
- Type of Material of Pump Body: Aluminum
- Number of Blades on Impeller: 6
- Direction of Rotation: Counterclockwise
- Number of Threaded Bracket Bolt Holes on Pump Body: None
- Bolt Hole Sizes: N/A
OTHER SPECIAL FEATURES:
- Impeller blades angled to shaft
- Impeller cavity directional to counterclockwise rotation
- Lower radiator hose inlet on left side(driver's side)
- Has rectangular backing plate ports
PARTS CONTAINED IN BOX:
- (1) Inner Backing Plate Gasket
- (1) Outer Backing Plate Gasket
- (1) Heater Hose Rubber Adaptor (1 1/8" O.D.)
- (1) Installation Sheet
- (1) FLOWKOOLER Decal
Other recommended parts:
Thermostat
Thermostat housing
Bypass hose
Radiator hoses
Heater hose kit
FlowKooler guarantees that its products are free from defects in faulty workmanship and defective materials for a period of two years from the purchase date. This warranty is valid only if it is determined to FlowKooler's sole satisfaction that the products are, and have been subjected to, ordinary use and service and have been properly installed by the purchaser (see instructions shipped with product).
FlowKooler’s Warranty is null and void if the product is or has been altered in any way e.g. polishing, chroming, powder coating used for racing, blown up, burnt stators or stripped rotor threads, cracked housings, blown bearings or shaft breakage, scratched or damaged due to incorrect installation and/or over-tightened.
This warranty does not apply to any product where failure is a result of misapplication, improper use, or maintenance nor is there any warranty expressed or implied as to the merchandise-ability of the product.
This warranty is valid for the original purchaser and is not transferable.
FlowKooler in no event shall be liable for labor, special or consequential damages, property damage or bodily injury or death or damages to or loss of use of any property directly or indirectly attributable to our products and under no circumstances any charges in excess of the invoice amount of the product proven to be defective.
If any product fails to conform to these warranties FlowKooler will, at its sole option and as its sole and exclusive liability hereunder, replace the product proven to be defective.
THIS WARRANTY PERTAINS TO PURCHASES MADE AFTER AUGUST 1, 2010. IT EXCLUDES ALL OTHER EXPRESSED OR IMPLIED WARRANTIES, ORAL OR WRITTEN WARRANTIES, INCLUDING WITHOUT LIMITATION WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
Ships Directly from Manufacturer
Normally takes 2-4 weeks
|
|
